 |
| Material: |
3/4" A2
Tool Steel |
| Description: |
This part was
a bottom backup plate for a die set. |
|
 |
| Material: |
3/8" Cold
Rolled Steel |
| Description: |
The part was
JetMachined. All interior holes were cut
undersized. |
|
 |
| Material: |
1/2" Cold
Rolled Steel |
| Description: |
During
JetMachining all holes in this part were cut undersized
for tapping. |
|
 |
| Material: |
3/8"
Stainless Steel |
| Note: |
Comparison of
two methods: top part JetMachined, bottom part produced
by Wire EDM |
| Description: |
Wrench that
was JetMachined was traced from original and scanned
into software. |
|
